This is the debris from 2 walls, a shower stall and an old vent fan. Didn't know so little could make such a big mess!

Looking up. I replaced the ceiling vent fan. Because the previous wires were too short to meet the new vent fan, I had to put in a juntion box too. Not the prettiest, but it meets code and works! Denny also sheetrocked the ceiling. I helped hold up the sheetrock while he screwed it in place.

A view of some of the new insulation and new studs Denny put in to make the shower install possible.

Another view of studs & insulation - and of course the shower stall.

Another view. By the way, notice, no shower head. There's absolutely no way to take a shower in this shower stall yet.

A view of where the new wall, with new studs and insulation meet the old next to the window. I'll have to remove the brown rectangles below the window. They were part of the toilet paper roll holder. They are destroyed, so of no good use now.

Another view of the shower stall, showing how there is no hole placement for any plumbing, other than the drain. I guess that makes sense. When they build it, they don't know where the consumer wants them.

A view of the cement mud at the underside of the shower stall. We placed the shower stall in first, then Denny mixed the cement and used a long stick to shove the cement under and in place. I had always wondered how it was done.
No comments:
Post a Comment